Watlow MINICHEF Deep Fat Fryer Application Instrukcja Użytkownika Pobierz pdf (Strona 104)

102 ■ Watlow MINICHEF 2000 Application 19

The Melt Cycle

To avoid burning congealed oil (shortening), a slow heating action may be necessary. If

this is desired, be sure that in the Configuration Mode [etype] / [melt] has been set

to [```on]. Then, when the oil temperature is below 212 °F the heat output will be lim-

ited to 10% of full power. This reduces the chance of burning congealed oil while it is

heating.

Run a Menu (with preheat feature)

This procedure describes how to run an active menu when the preheat feature is active

— in other words, when the [ready] parameter in the [setUp] function of the

Configuration Mode is set to [``yes].

1. Set the menu as shown earlier.

2. With [`idle] or time of day on the display, press the Start/Stop key.

If the menu’s preheat condition has not been met, the fryer will preheat until

[Ready] appears on the display. If the fryer is at operating temperature [Ready]

will immediately appear on the display.

3. With [Ready] on the display, place the food in the basket and press the Start/Stop

key (indicated be the flashing red light). The Start/Stop indicator light will light up

and time will count down on the display.

4. When the cooking cycle is finished [``End] will appear on the display and an audi-

ble tone will be emitted. The menu key indicator light will flash rapidly. You can

acknowledge and silence the tone by pressing the active menu key or it will time out

in 2 seconds and go into idle.

5. Remove the food from the fryer. The controller will continue to regulate to the last

set point.

6. To repeat cooking, repeat steps 1 through 6.

Run a Menu (without preheat feature)

This procedure describes how to run a menu when the preheat function is inactive —

MINICHEF 2000

[ready]

Edit Accept

Back-UpExit

MINICHEF 2000

[`0009]

Edit Accept

Back-UpExit

STEADY

MINICHEF 2000

[``EnD]

Edit Accept

Back-UpExit

MINICHEF 2000

[`idle]

Edit Accept

Back-UpExit

G H

AAB

RAPID FLASH

MINICHEF 2000

[`idle]

Edit Accept

Back-UpExit

SLOW

FLASH

AT OPERATING TEMPERATURE

(PREHEAT CONDITION MET)

RAPID

FLASH

MINICHEF 2000

[100f`]

Edit Accept

Back-UpExit

MINICHEF 2000

[ready]

Edit Accept

Back-UpExit

G H GH

A A

[pre-`] [`Heat]

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 110 111

Komentarze do niniejszej Instrukcji

Brak uwag

Watlow MINICHEF Deep Fat Fryer Application Instrukcja Użytkownika Strona 104

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czujniki Watlow MINICHEF Deep Fat Fryer Application